How to start a new XPJ-1341SR-P with MS51 inks

The document describes all necessary steps to load MS51 inks into a new XpertJet1341SR-Pro printer.
Please follow the procedure below in order to correctly install our MS51 inks. 

Required items:

1. Firmware V1.06 and MSA 5.1.2.0 (or higher)
2. High capacity ink pack adaptors: 1x VJ-HCIPADPT (1 contains 4 adaptors)
3. Cleaning & Ink:

• MS31 220 ml cleaning cartridges for the initial cleaning cycle
  
  

  XPJ-1341SR-P
  Part N°	#
  VJ-MS31-CL220E	4

• MS51 ink for XPJ-1341SR-P
  
  

  XPJ-1341SR-P
  Part N°	#
  MS51-BK1000E	1
  MS51-CY1000E	1
  MS51-MA1000E	1
  MS51-YE1000E	1

• Cleaning fluid to carry out the daily maintenance: VJ-ULVA1-ML500
  
   

Procedure:

• First of all load the FW 1.06 (or higher) on the printer in order for the printer to accept the MS51 smart cards. 

• Boot the printer in “User Mode” and enter the initial settings (language, IP address…).
• Activate the printer.
• Reboot the printer.
• Perform the “initial cleaning – initial ink charge”: 

           (please consult the Start-up guide for detailed instructions on how to correctly load the cleaning/ink):
 

• Unpack and insert the MS31 220ml Cleaning cartridges
• After the cleaning cycle the display will show: "Wash Retry?" -> Choose No

• Insert the MS51 ink packs in the high capacity pack adaptors, install them in the printer and insert the smart cards.
• The "Ink Charge" with the MS51 inks will be initiated.

• Once the ink has been loaded, following message will appear (ink charging cycle is completed): "Media End".