Adding a GCC Jaguar cutter to VerteLith

Modified on Fri, 16 May, 2025 at 9:24 AM

As you may know, GCC cutters are not officially supported in VerteLith.

However, you can try the following workaround:

Add ValueCut as a cutter in VerteLith.

Manually enter the IP address as 127.0.0.1.

You may receive an error message—ignore it and continue by clicking Next through the setup steps.

Go to Manage Cutters.

Edit the IP address of the cutter to match the actual IP address of your GCC cutter.

Again, ignore any error messages and continue by clicking Next as needed.

Please note: This method is not guaranteed to work.